1
Open the door fully
and hold the two
door hinges.
2
Lift and turn the
levers on the two
hinges.
3
Close the oven door
halfway to the first
opening position.
Then pull forward
and remove the
door from its seat.
Put the door on a
soft cloth on a
stable surface.
Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
Pull the door trim to the front to remove it
Hold the door glass panels by their top
edge and carefully pull them out one by
one. Start from the top panel. Make sure
the glass slides out of the supports
completely.
Clean the glass panels with water and
soap. Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels (A,
B and C) back in the correct sequence. The
middle panel (B) has a decorative frame.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame (B) on the screen-printing
zones is not rough when you touch it.
ENGLISH
22
To Next Page
Loading...
