Display
BA
The display shows the following information:
•
A
–Child safety lock.
This device permits you to leave the appliance un-
attended during it's functioning.
•
B
– Duration of the selected programme.
After selecting a programme, the duration is dis-
played in hours and minutes (for example
).
The duration is calculated automatically on the ba-
sis of the maximum recommended load for each
type of fabric. After the programme has started,
the time remaining is updated every minute.
– Selected drying time
After selecting a drying programme the drying
time is shown in minutes or hours and minutes. Af-
ter the programme has started, the time remaining
is updated every minute.
– Delayed start.
The Selected delay set by pressing the relevant
button appears on the display for a few seconds,
then the duration of the selected programme is dis-
played again. The delay time value decreases by
one unit every hour and then, when 1 hour re-
mains, every minute.
–Alarm codes.
In the event of operating problems, some alarm co-
des can be displayed, for example
(see
paragraph «What to do if...»).
– Incorrect option selection.
If an option which is not compatible with the set
wash programme is selected, the message Err is
displayed at the bottom of the display for a few
seconds and the integrated red indicator light of
button 5 start flashing.
– End of programme.
When the programme has finished the flashing
zero (
) is displayed, the indicator light 4 and the
indicator light of button 5 go out and the door can
be opened.
Delay Start button The programme can be delayed from 30 min - 60 min -
90 min, 2 hours and then by 1 hour up to a maximum of
20 hours by means of this button.
ENGLISH 10
To Next Page
Loading...
