5
Good to know
Without DIRIGERA, you can connect a maximum of 10
smart products to one dimmer/switch. Remember to add
one product at a time. If your products are close together,
disconnect the ones you have already connected while
adding the next product.
Get to know your product
Pairing button
Press to turn on, or long-press to increase brightness
Presstoturno,orlong-presstodecreasebrightness
Changing the battery
A red LED light will blink when you press any button the
dimmer/switch to show that a new battery is needed. Open
the battery lid and replace with a new AAA/HR03 battery.
We recommend using a LADDA rechargeable battery.
Please note it is sold separately.
Factory reset
To reset and remove all connected products, quick-press
the pairing button 4 times (within 5 seconds). Follow steps
1-3 to reconnect your smart products.
Care instructions
To clean the product, wipe it with a soft cloth moistened
with a little mild detergent. Use another soft, dry cloth to
wipe dry. Never use abrasive cleaners or chemical solvents
as this can damage the product.
To Next Page
Loading...