EasyManua.ls Logo

IKEA SILVERGLANS - Steering Your Lighting; Pairing Steering Device; Factory Resetting Driver; Important Usage and Safety Notes

IKEA SILVERGLANS
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4English
HOW TO STEER YOUR LIGHTING
When the driver is connected to the
mains, it is possible to turn ON/OFF
all products connected to the driver,
but if you want to dim or connect
your products to IKEA Smart lighting
products, you need to buy a separate
steering device (e.g. a remote control).
The steering device needs to be paired
with your driver/s. If you have more
than one (1) driver you can pair each
one with the steering device, so that the
entire combination can be turned ON/
OFF or dimmed at the same time.
PAIRING A STEERING DEVICE TO
YOUR DRIVER
1. Connect at least one (1) product
to the driver before you begin the
pairing. Make sure that the mains
power is turned ON.
2. Locate the pairing symbol on the
driver. Hold the steering device close
to the pairing symbol (no more than
5 cm away).
3. Press and hold the pairing button
on the steering device for at least
10 seconds. A red light will shine
steadily on the steering device.
The product connected to the driver
will begin to dim and ash one time
to indicate that the driver is being
paired to the steering device.
HOW TO FACTORY RESET
YOUR DRIVER
If the driver does not respond or if
you want to un-pair the driver from a
steering device you might have to make
a factory reset. The driver is forced to
factory reset by carefully push and hold
the small button (marked RESET) with a
tip of pen on the driver enclosure and
applying a slight pressure. A factory
reset can also be done by toggle the
main switch 6 times.
IMPORTANT!
The driver is for indoor use only and
can be used in temperatures ranging
from 5ºC to 45 ºC (41ºF to 113 ºF).
Do not leave the driver in direct
sunlight or near any heat source, as it
may overheat.
The declared radio range between
the driver and the steering device
is measured in open air. Dierent
building materials and placement
of the units can aect the wireless
connectivity range.
CARE INSTRUCTIONS
To clean the driver, wipe with a dry soft
cloth.
Never use abrasive cleaners or chemical
solvents as this can damage the
product.
PRODUCT SERVICING
Do not attempt to repair this product
yourself, as opening or removing covers
may expose you to dangerous voltage
points or other risks.
TECHNICAL DATA
Type: ICPSLC-24-30-IL44-1
Input: 100-120 VAC, 50/60 Hz, 0.51A
Output: 24.0V DC
Max total load: 1.25 A, 30.0 W
Radio range: 10 m in open air.
Operating frequency: 2405-2480MHz
Output power: 14 dBm
IP-class: IP44
Indoor use only
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN

Related product manuals