ENGLISH 4
FUNCTIONS
1. POWER button
2. LED indicators
3. Micro-USB (only charging)
4. USB (only supply power)
OPERATING INSTRUCTIONS
Use either the micro-USB cable that
comes packaged with this product,
or a high-performance USB travel
charging cable.
CHARGING POWER BANK
— Connect the micro-USB cable
end to the powerbank rst and
then connect the USB-cable to a
USB-charger or USB-outlet that
can provide sufcient power to
charge the powerbank.
The LED indicators will display the
charging status.
SUPPLY POWER TO DEVICES
— Connect the USB cable end to the
powerbank rst and then connect
the USB-cable to your device you
want to charge.
— The LED indicators will display
the remaining charge in the
power bank during discharging.
CHECK POWER STATUS
— Push and hold the POWER-button
and the LED indicators will light
up and indicate the remaining
power status.
— The power bank will detect a
connected device and start
charging automatically.
— If the USB cable not is
disconnected while charging
process nishes, push POWER-
button rst to start charging.
NOTE:
Be sure to check the orientation of
the terminal before connecting,
Connecting incorrectly may damage
the connector.
GOOD TO KNOW
— It is normal for the battery pack
to become hot during charging
and it will gradually cool down
after charging.
— Charging time may vary
depending on remaining charge,
battery age and ambient
temperature.
— Battery pack storage
temperature: -20°C to 25°C.
— Charger operation temperature:
0°C to 45°C.
— Disconnect the power bank from
the power outlet before cleaning
or when it is not used.
Use damp cloth when cleaning the
power bank. Do not immerse into
water.
To Next Page
Loading...
