IKEA SVAVANDE - Product Description; Control Panel

8 ENGLISH
Product description
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel
Control Panel
S0614 (170201)
backlight symbols
112
20 20 20 20
8
S0614 (170201)
backlight symbols
A B C D E
BUTTON FUNCTION
A =
Speed
Turn the motor on/o at speed one. Turn o each speed.
B =
Speed
Turn the motor on at speed two / Activate charcoal lter alarm
Pressand hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights), to turn the
Activated Charcoal Filter alarm on. LED (A) ashes twice to conrm.
To Deactivated Charcoal Filter alarm o, press the button again and hold for at least 2 seconds.The relevant
LED ashes once (A). Only for recirculation mode. (please refer to page 7)
C =
Speed
Turn the Motor on at speed three / Reset alarm grease and charcoal lter saturation
Pressand hold the button for approximately 2 seconds, with all the loads turned o (Motor+Lights),
to reset the grease and charcoal lter saturation alarm. LED (A) ashes three times.
D =
Speed
Turn the motor on at Booster speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed
that was set before. If it is activated with the motor turned o, it will switch to OFF at the end of the time. To
deactivate it, press button D or press button A
E =
Light
Pressbriey: Turn the lighting system on and o at maximum intensity.
Pressand hold to change the lighting intensity up or down.