IKEA TINAD - Installation; General Installation Safety

ENGLISH 7
To avoid food contamination,
please observe the following:
– Opening the door for long
periods can cause a signicant
increase of the temperature in the
compartments of the appliance.
– Regularly clean surfaces that may
come into contact with food and
accessible drainage systems.
– Clean water tanks if they have
not been used for 48 h; ush
the water system connected to
a water supply if water has not
been drawn for 5 days.
– Store raw meat and sh in
suitable containers in the
refrigerator, so that it does not
come into contact with or drip
onto other food.
– Two-star frozen food
compartments are suitable for
storing pre-frozen food, storing or
making ice cream and ice cubes.
– Do not freeze fresh food in one,
two or three-star compartments.
– If the refrigerating appliance is
left empty for long periods, switch
off, defrost, clean, dry, and leave
the door open to prevent mould
developing inside the appliance.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including
water supply (if any), electrical
connections and repairs must
be carried out by a qualied
technician. Do not repair or
replace any part of the appliance
unless specically stated in the
user manual. Keep children away
from the installation site. After
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.)
must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
from the power supply before
any installation operation - risk of
electric shock. During installation,
make sure the appliance does not
damage the power cable - risk of
re or electric shock. Only activate
the appliance when the installation
has been completed.
Be careful not to damage
the oors (e.g. parquet) when
moving the appliance. Install the
appliance on a oor or support
strong enough to take its weight
and in a place suitable for its size
and use. Make sure the appliance
is not near a heat source and
that the four feet are stable and
resting on the oor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant circuit
is fully efcient.