IKEA UDDEN - Grease Filter; Lamp Replacement; Charcoal Filter Fitting

ENGLISH 8
Greaselter
The metal grease lter has unlimited
duration. It should be washed at least once
a month, either by hand,
or by placing it in the dishwasher (use a
short cycle and low temperature).
If washed in the dishwasher, the grease
lter surface may become matt. This will not
cause any reduction of performance.
• To remove the lter pull out the handle.
After the lter has been washed and dried,
replace following the inverse procedure.
Replacingthelamp
1. Disconnect the hood from the electric
power supply.
2. Open the the grease lter.
3. Remove the burnt-out lamp. Use 28W
max. halogen E14 lamps only.
4. Ret the grease lter.
Fittingorreplacingcharcoallter
Replace the charcoal lter every 4
months. The lter may not be washed or
regenerated.
1. Disconnect the hood from the electric
power supply.
2. Remove the grease lter.
3. Apply the lter so that it covers the
protection grid of the suction motor,
ensuring that the S holes correspond
with the hooking pins R on the side of
the suction motor protection grid.
4. Turn the carbon lter clockwise to lock in
position (bayonet mount).
5. Ret the suction grid or the grease lter.
To remove the charcoal lter follow the
inverse procedure.
S
R