Removable Battery Plate
The White Collar Lock Button must be
p
ushed “forward” and held to release
the Collar. Hold the body with one
hand while pushing the White Collar
Lock button forward with your finger.
Slide the Collar up about 1/4” to
its “open” position while holding the
Collar Lock Button forward.
The Collar Lock Button can now be
released and the front of lite can be
pulled from the body.
NNOOTTEE::
Lithium-ion batteries are not recommended. Use of
lithium-ion batteries can lead to shortened LED life or LED failure.
Lift out the removable top battery plate and load six “AA” size alkaline
batteries into the body. Note the polarity chart is engraved on top of the
removable plate. Install batteries into the light body and then place the
top plate back into the body.
The “O” ring must be clean and have a very light coating of
silicone lube on the surface. Push the front into the body,
hhoollddiinngg iitt
ttiigghhttllyy iinn ppllaaccee
while pushing the Collar Lock back to the closed position.
Check that the Collar Lock Button has clicked into place securely.
P
ush White Collar Lock
button forward
and hold
S
lide Collar Up 1/4”
to its Open Position
Pull front of Lite
from body
O RING
PPCCaa --
LLEEDD
LLiigghhtt
LLUUBBRRIICCAANNTT IISS PPAACCKKEEDD IINN
TTHHEE FFOOLLDD OOFF TTHHEE CCAARRTTOONN
The PCa-LED Light runs cool and can
be used for extended periods of time
above or under water.
IIkkeelliittee UUnnddeerrwwaatteerr SSyysstteemmss
50 W 33rd Street
Indianapolis, IN 46208
317-923-4523
Email - ikelite@ikelite.com
Web Site - www.ikelite.com
Collar
Collar Lock Button
Switch
Switch Lock
To Next Page
Need help?
General