Considerations:
If you are not an experienced installer it is advised that you have your authorized
Image Dynamics dealer complete the installation for you. Follow these simple
guidelines for best results. Carefully plan out your installation before beginning.
Check for proper clearance and depth before cutting or altering your vehicle in
any way.
It is recommended to run new wires into the door location rather than using the
factory systems wiring. Mount speakers only to a flat and rigid baffle. A baffle that
vibrates or resonates will severely degrade sound quality. Ensure that the
speakers are protected from water damage. Most parts of the XS speakers are
water resistant but prolonged exposure to moisture can damage the spider and
motor structure.
POINT SOURCE TWEETER MOUNTING INSTRUCTIONS
Remove phase plug by twisting in counter clockwise direction to un-screw it from
the pole piece of the speaker.
Remove tweeter flush mount trim ring and replace with coaxial mounted trim
ring.
Mount tweeter to tweeter stand. Slide tweeter wire through the center hole in
the black tweeter adapter stand and screw threads of the adapter into threads on
the rear of the tweeter
Remove the rear magnetic label from the mid-bass speaker and save for
reassembly.
Insert wire through hole in pole piece of the XS mid-bass and screw the tweeter
assembly into the threads in the top of the mid-bass driver pole piece. Make sure
to tighten snugly to prevent vibrations but do not over tighten.
Route the tweeter wires in the groove up to the terminal on the side of the basket
and connect the copper colored wire to the positive terminal and the silver
colored wire to the negative terminal.
Replace the rear magnetic label.
To remove tweeter from XS mid perform above steps in reverse order
To Next Page
Loading...