To Next Page

To Previous Page

Foreword

First, allow us to express our thanks that you have decided on this product. We wish you total success

in accomplishing your measurement assignments with the help of the imc hardware and software.

If there are any open questions about our products, please contact our Hotline (hotline@imc-

berlin.de).

Disclaimer of liability

The contents of this documentation have been carefully checked for consistency with the hardware

and software systems described. Nevertheless, it is impossible to completely rule out inconsistencies,

so that we decline to offer any guarantee of total conformity.

We gratefully accept any suggestions for improvements, please contact our Hotline (hotline@imc-

berlin.de).

We reserve the right to make technical modifications of the systems.

This documentation is the intellectual property of imc Meßsysteme GmbH. imc Meßsysteme GmbH

reserves all rights to this documentation. The applicable provisions are stipulated in the "imc Software

License Agreement".

The software described in this document may only be used in accordance with the provisions of the

"imc Software License Agreement".

imc Software and Microsoft® Windows

imc software runs on the Microsoft® Windows operating system. Microsoft Windows provides a

standardized user interface for imc software and all other Windows-applications.

A license for the respective version of Microsoft Windows is required.

Microsoft, MS and MS-DOS are registered trademarks and Windows is a trademark of Microsoft

Corporation.

Intel and Pentium are registered trademarks of Intel Corporation, USA.

All other trademarks are the property of their respective companies.

GPL Sources

Some components of our hardware use software, that is licensed under GNU General Public License

(GPL). If you would like a copy of the GPL source code contained in this product please contact the imc

Hotline.

IMC CANSAS Getting Started

Other manuals for IMC CANSAS