11
GB
Clean the dust collection system (9) as described below and take note of the fi gures in the image section.
Cleaning the dust collection system (9)
• Press the dust collection release button (8) [Fig. F1] and remove the dust collection system (9) from the
appliance [Fig. F2].
• Push the bottom lid opening button (9C) to open the dust holding cover (9B) [Fig. F2], and empty its
content.
• When necessary, rinse the container and let it dry thoroughly for at least 24 hours (always keep it away
from heating sources).
Cleaning the cyclone fi lter (9A):
• Press the dust collection release button (8) [Fig. F1] and remove the dust collection system (9) from the
appliance [Fig. F2].
• Push the bottom lid opening button (9C) to open the dust holding cover (9B) [Fig. F3].
• Extract the cyclone fi lter (9A) by handling it thorough the ad-hoc slits and by pulling it out [Fig. F4].
• If the cyclone fi lter (9A) is clogged up due to dust, wash it carefully in cold water. Be careful not to
damage the fi lter and allow it to dry completely for at least 24 hours after washing.
• For installation, insert the cyclone fi lter (9A) on the holder so that the fi lter lower side cog (arrow) is
placed in the engraving of the fi lter holder [Fig. F5].
• Close the bottom lid (9C) and insert the dust collection system (9) back into the appliance before
operating it again.
Cleaning the Pre-engine fi lter (14)
• Press the dust collection release button (8) [Fig. F1] and remove the dust collection system (9) from
the appliance [Fig. F2].
• Remove the fi lter holder (14B) by pulling on the handle located at the centre [Fig. F6].
• Separate the sponge fi lter (14A) from the fi lter holder (14B) and clean them gently with a cloth.
• Once they are cleaned, put the fi lters back in their housing so that the locking system is enabled (14).
• Insert the dust collection system (9) back into the appliance before operating it again.
Note: Depending on the use of your appliance, fi lters must be replaced annually.
To Next Page
Loading...