Instructions Instrucciones Gebrauchs Instructions
INAC Electrónica para radiocomunicaciones P.O. 3101 50080 Zaragoza España
Tel. +34 976 322 822 http://inac-radio.com e-mail: inac@inac-radio Pág.: 12
we recoMMenD an initial test anD antenna connection
Must contain the packaging:
- e antenna, with its iron bracket with four screws Allen.
- Handbook AH-521 antenna you are reading.
- Manual control of LAC-1
- Five-meter cable with quick connectors at each end.
- Cable with connector and tab to the xed wiring.
- Command LAC-1
to know that it works:
- To do this, with the antenna on a table .... No touching the transmission, not dan-
gerous, but if unpleasant, with possible points of skin burns.
- Connect the control unit to the antenna
- Provide voltage of 12 Volts
- Connect the antenna to a receiver or transceiver
- Press the red button and hold it down, sweep the smaller and outer knob from right
to le and stop when you hear blowing or increase any transmission.
- Find a new station and antenna retouching.
- Proven to work, prepare the nal location for your antenna.
To Next Page
Loading...