inbody 270 - Quick Installation Guide Manual

InBody
Keep the box right side up.
Slice between the flaps to open the
unit box. Do not cut too deeply or
you may damage the contents.
Unfold and take out all the padding
on top to reveal the unit.
Once you place the unit on the
ground, use one hand to hold the
footplate and the other hand to
push the head upright to a vercal
posion unl you hear a click.
Li the unit up from the box,
making sure you are holding onto
the footplate with both hands.
Keep the footplate horizontal to
the ground.
(This may require two people)
Do not cut too deep when opening up the unit box. Cung too deep may damage the InBody unit and/or unit padding.
Your InBody 270 package comes with the following:
 
| Quick Installaon Guide
www.inbody.com
1
4 5 6
2 3
UNBOXING + ASSEMBLY
Tilt the head upright and
straighten out the handles.
Check the level indicator to
see if the unit is balanced.
If not level, adjust the four
footplate supports unl the
bubble is inside the red ring.
Rotate clockwise to lower the
height of the support or
counterclockwise to raise it.
Connect the adapter to the
power input port located on
the rear panel of the unit.
Connect the adapter to the
power cord. Plug the power
cord into an outlet.
Leveled
Not leveled
Level Indicator
Adapter User’s Manual
Power CordInBody 270
