EasyManua.ls Logo

Industrial Air IV5076055 User Manual

Industrial Air IV5076055
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Operator Manual
Manuel de l’opérateur
Manual del operador
Electric Two–Stage Air Compressors
Compresseurs d’air électriques à deux étapes
Compresores de aire eléctricos de dos etapas
Français, p. 13-23
Español, p. 24-34
200-2927
Revision G
200-2927_Revision G_6/4/18
WARNING:
Read and understand all safety precautions in this manual before operating. Failure to comply with instructions in
this manual could result in personal injury, property damage, and/or voiding of your warranty. The manufacturer WILL NOT be liable
for any damage because of failure to follow these instructions.
AVERTISSEMENT:
Lire et s’assurer de bien comprendre toutes les consignes de sécurité du présent manuel avant
d’utiliser l’outil. Toute dérogation aux instructions contenues dans ce manuel peut entraîner l’annulation de la garantie, causer des
blessures et/ou des dommages matériels. Le fabricant NE SAURA être tenu responsable de dommages résultant de l’inobservation
de ces instructions.
ADVERTENCIA:
Lea y comprenda todas las precauciones de seguridad contenidas en este manual antes de utilizar esta
herramienta. El no cumplir con las instrucciones de este manual podría dar como resultado la anulación de su garantía, lesiones
personales y/o daños a la propiedad. El fabricante NO SERA responsable de cualquier daño debido a no acatar estas instrucciones.
NOTE: These units DO NOT require a magnetic
starter.
REMARQUE : Ces compresseurs ne nécessitent
pas l’installation d’un démarreur magnétique.
NOTA: Estas unidades no requieren la
instalación de un arrancador magnético.

Questions and Answers:

Industrial Air IV5076055 Specifications

General IconGeneral
ModelIV5076055
CategoryAir Compressor
TypeStationary
Power SourceElectric
Max Pressure155 PSI
Horsepower5 HP
Voltage230 Volts

Summary

Safety Guidelines

Hazard Definitions

Defines DANGER, WARNING, and CAUTION symbols used in the manual for hazard identification.

Important Safety Instructions

Risk of Fire or Explosion

Precautions against fire and explosion risks during operation.

Risk of Bursting

Safety measures to prevent tank bursting and modifications.

Risk of Electrical Shock

Guidelines to prevent electrical shock hazards during operation.

Risk of Injury

Safety advice to avoid injury from moving parts and during operation.

Risk of Burns

Warning about hot components and preventing burns.

Risk to Breathing/Inhalation Hazard

Safety instructions for using respirators and working in ventilated areas.

Risk of Eye Injury

Mandatory use of safety goggles and avoiding pointing nozzles.

Risk to Hearing

Importance of wearing hearing protection during operation.

Electrical Wiring Safety

Requirements for proper electrical wiring by a licensed electrician.

Lead Exposure Warning

Information on potential exposure to lead and its health effects.

Cautionary Measures

Safety advice on draining moisture, ventilation, and transporting.

Assembly

Typical Installation

Compressor Controls

Electrical Power Requirements

Operating Instructions

Break-in of the Pump

Procedure for the initial break-in period of the pump.

Daily Start-up

Step-by-step guide for starting the compressor daily.

Shutdown Procedure

Steps for safely shutting down and draining the compressor.

Maintenance

Testing for Leaks

Troubleshooting

Excessive Current Draw

Troubleshooting for circuit breaker trips or motor reset switch activation.

Compressor Stalls

Causes and solutions for the compressor stopping during operation.