Inficon BM1000 Series - Remove the Bus Module from the DIN-TS35 Top hat Rail

INFICON Installation and removal | 5
BM1000-Operating-Instructions-jiqb10en1-06-(1901) 11 / 20
2
Connect the bus module with the external controller by means of the built-in field
bus module.
The bus module is activated in the leak detector, e.g. the MSB box of the LDS3000,
see the leak detector manual.
Communication with field bus master
For information on establishing communication with the Field bus master, see
Interface protocols, jira54 and kirb43.
5.3 Remove the bus module from the DIN-TS35 top
hat rail
Fig.3: Removing the bus module
1. Use the flat-tip screwdriver to pull out the locking device.
2. Pull the device off of the top hat rail.