8-7 Maintenance
kina22e chapter 8.fm technical handbook(1206)
6 Insert new operation fluid reservoir into the pump up to the O-Ring (see Fig. 8-6).
7 Re-assemble bottom lid. Make sure that the O-ring remains in the correct position,
as otherwise large leaks can occur.
Notice: The bottom lid will align the operation fluid reservoir to the correct axial
position.
8 From the main menu go to HISTORY & MAINTENANCE / CONFIRM MAINTENANCE and
confirm with the appropriate button on the right side of the display that the operation
fluid reservoir has been replaced / cleaned.
The actual date and time as well as the actual number of operating hours will be
saved and a reminder for maintenance will be issued again after 3 years.
Notice: The Ecotec E3000 must be set to
ADVANCED mode for confirming
maintenance tasks.
Fig. 8-6 O-Ring of operation fluid reservoir
Do not completely push in the operation fluid reservoir. The operation fluid reservoir
is correctly positioned by the cover after screwing it in.
To Next Page
Loading...
