Maintenance 8-8
kina22e chapter 8.fm technical handbook(1206)
8.5 Exchanging the mains fuses
Use a screw driver to fold out the lid of the mains socket from the right (the mains
switch is not affected by this).
The fuses can be removed by pulling out the drawers which are marked by the
arrows. On re-inserting these, make sure that the arrows point upwards.
The two fuses must be replaced by two fuses of the same rating. The required mains
fuses are available as cat.-no. 200 000 914.
After having exchanged the fuse(s) firmly reclose the lid of the mains socket.
Re-connect the mains cord to the Ecotec E3000 and switch on the Ecotec E3000.
Before exchanging the fuses you must disconnect the mains cord.
Only fuses of the specified type and rating are to be used as replacements.
Fig. 8-7 Replacing the mains fuse
To Next Page
Loading...
