General Information 1-7
kina22e chapter 1.fm technical handbook(1206)
1.3 Unpacking
Unpack the Ecotec E3000 leak detector immediately after it has been received even
if it is to be put into operation at some later date. Examine the shipping container for
any external damage. Completely remove all packaging materials.
Notice: Retain the shipping container and the packaging materials in the event of
possible complaints concerning any damages.
Check if the Ecotec E3000 leak detector is complete (see Section 1.3.1) and carefully
subject it to a visual inspection. If any damage is discovered please immediately
inform the forwarding agent and the insurers. If it is required to exchange the
damaged part please contact our orders department.
1.3.1 Supplied Equipment
The Ecotec E3000 leak detector is ready for operation. Before installation please
read Section 1.5. Included with the leak detector are the following items:
• Ecotec E3000 (main unit)
• Mains cord, 3m long
• Set of fuses (3 x 10 pcs.)
• Spare air filter
• 8 mm hexagonal wrench
• 19 mm ring wrench
• Documentation
– Operating Instructions (kima22e1)
– Technical Handbook Ecotec E3000 (kina22e1)
– Spare Parts List Ecotec E3000 (kiua22d2)
– Interface Description E3000 (kins22e1)
Notice: The sniffer line is available in different configurations and needs to be
ordered separately in the desired length. The sniffer line is not part of the
Ecotec E3000 shipment. (see Section 1.3.3 Accessories)
Notice: The ECO-Check reference leak is an accessory (see Section 1.3.3
Accessories) and needs to be ordered separately
Notice: For the Ecotec E3000RC version the display unit and the connecting cable
are not part of the standard Ecotec E3000 shipment and need to be
ordered separately (see Section 1.3.3)
To Next Page
Loading...
