Equipment Settings 4-39
kina22e chapter 4.fm technical handbook(1206)
4.9 Monitoring Sensitivity
It is highly recommended to always keep the SENSITIVITY CHECK function enabled.
This function should only be disabled when operating in argon-free environment as
the argon signal is used for monitoring.
For details on this function see Section 4.5.1 (“Sensitivity Check”)
If sensitivity changes,
ERROR CODE E30 will be displayed. In this case, please
recalibrate the Ecotec E3000 to restore sensitivity (see Section 3.5).
The error code will be displayed every 15 seconds until a recalibration is started.
To Next Page
Loading...
