Inficon UL3000 Fab ULTRA - 4.3 Device setup

4 | Description INFICON
20 / 152 UL3000-Fab-ULTRA-Operating-instructions-iinb73en1-09-(2109)
Acknowledge calibration
via a button on the sniffer
probe
-
YES
4.2.3 Operation mode “Auto Leak Test”
In this mode, you can perform tests on hermetically sealed components with
automated processing. If the optional test chamber TC1000 is used, the test starts
automatically when the cover is closed.
Results are achieved within a very short time. The internal calibration leak of the leak
detector is used to dynamically calibrate the desired test cycle.
Leak rates in the range of 10
-9
mbar can be detected within 5 seconds.
4.3 Device setup
4.3.1 Overall device
Fig.1: Front view