Inficon UL3000 Fab ULTRA - Switch on Automatic Login; Presentation of the Measurement Screen

INFICON Operation | 6
UL3000-Fab-ULTRA-Operating-instructions-iinb73en1-09-(2109) 55 / 152
6.2.5 Switch on Automatic Login
You can specify if a user of your choice is automatically logged in after the device is
switched on without the login window.
ü
Supervisor
rights
ü The requested user was already created. See "Select, modify, create user profile
[}53]".
1
> User accounts > Manage Automatic Login
2
In the “Manage Automatic Login” window, activate the option “Active”.
3
Enter the name of the user in the "Name" field. Note the uppercase/lowercase.
4
Enter the current PIN of the user profile in the "PIN" field.
5
Save .
6.2.6 Presentation of the measurement screen
To switch between the different diagram presentation press on the lower left of the
measurement screen, see "Assembly of the touchscreen [}27]”.
You can select between the following presentations:
• Line chart
• Bar chart
• Circle chart
You can further configure the different diagram presentations. See "Changing the
presentation of the line graph [}56]", "Changing the presentation of the bar graph
[}57]", "Changing the presentation of the circle graph [}58]".
See also
2 Changing the presentation of the line graph [}56]
2 Changing the presentation of the bar graph [}57]
2 Changing the presentation of the circle graph [}58]