Inficon UL3000 Fab ULTRA - 6.7 Information

INFICON Operation | 6
UL3000-Fab-ULTRA-Operating-instructions-iinb73en1-09-(2109) 85 / 152
If storage is needed for the recording and the maximum database size (in
measurement values) has been exceeded, the oldest records are automatically
deleted so that 5% of the specified capacity is freed for new data.
ü
Supervisor
rights
►
> Measurement data > Database information
ð The following is displayed:
"Current database size" in [Byte]
“Measurement values“: Number of measurement values in the database
“Max. database size": Number of measurement values that can be stored in
the database
“Level“
“Oldest record“: Time stamp of the oldest measurement value
“Newest record“: Time stamp of the newest measurement value
See also
2 Resetting to factory settings [}93]
6.7 Information
6.7.1 Call the latest information to the current measurement
value
►
> Measurement values > Leak rate and pressure
ð The leak rate and different pressure values are shown.
►
> Measurement values > Temperature
ð Different temperature values are displayed.
►
> Measurement values > Run times
ð The current runtime information is displayed.
6.7.2 Call the latest information to the current calibration value
►
> Calibration
6.7.3 Information on connected accessories
►
> Accessories > I/O module
ð If an I/O module is connected, you will find details.