Inficon XL3000flexRC - Changing the Display of the Axes

6 | Operation INFICON
42 / 108 XL3000flex-Operating-instructions-jina83en1-07-(2105)
Control unit Main menu > Settings > Set up > MS module > Ion source >
Cathode selection
LD protocol 530
ASCII protocol *CONFig:CAThode *STATus:CAThode
6.2.10 Changing the display of the axes
The touchscreen grays out the parameters if
• the user is not authorized to modify the values,
• the older version of the software run by mass spectrometer module LDS3000 does
not support this parameter.
Scaling of the Q(t)axis
Linear or logarithmic
Lin.
Log.
Control unit Main menu > Display > Q(t) axis > Linear or logarithmic
Number of decades with logarithmic view
1
2
3
4
Control unit Main menu > Display > Q(t) axis > Decades
Autoscale
Off
On
Control unit Main menu > Display > Q(t) axis > Automatic scaling
Scaling of the time axis
Scaling of the time axis
15 s
30 s
60 s
120 s
240 s
480 s
960 s
Control unit Display > Time axis > Time axis scale