Infineon TRAVEO T2G - 19.5.1.18.12 PASS_SAR_CH_ENABLE

Technical Reference Manual 002-29852 Rev. *B
19.5.1.18.12 PASS_SAR_CH_ENABLE
Description:
Enable register
Address:
0x40900838
Offset:
0x38
Retention:
Retained
IsDeepSleep:
No
Comment:
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:1] CHAN_EN
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 CHAN_EN RW R 0 Channel enable.
- 0: the corresponding channel is disabled.
Corresponding trigger will be reset immediately.
- 1: the corresponding channel is enabled.
Note: To disable a group either stop the trigger first or
begin with disabling the lowest channel first. To enable
a group either start with enabling the last channel first
and the first channel last, or start the trigger after all
channels are enabled. If these rules are not followed
the result is undefined.
1122
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers