Infineon TRAVEO T2G - Page 115

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
6 SWE RW1C RW 0 Stop Watch Event
0= No rising/falling edge at stop watch trigger pin
m_ttcan_swt detected
1= Rising/falling edge at stop watch trigger pin
m_ttcan_swt detected
7 GTW RW1C RW 0 Global Time Wrap
0= No global time wrap occurred
1= Global time wrap from 0xFFFF to 0x0000 occurred
8 GTD RW1C RW 0 Global Time Discontinuity
0= No discontinuity of global time
1= Discontinuity of global time
9 GTE RW1C RW 0 Global Time Error
Synchronization deviation SD exceeds limit specified
by TTOCF.LDSDL, TTCAN Level 0,2 only.
0= Synchronization deviation within limit
1= Synchronization deviation exceeded limit
10 TXU RW1C RW 0 Tx Count Underflow
0= Number of Tx Trigger as expected
1= Less Tx trigger than expected in one matrix cycle
11 TXO RW1C RW 0 Tx Count Overflow
0= Number of Tx Trigger as expected
1= More Tx trigger than expected in one matrix cycle
12 SE1 RW1C RW 0 Scheduling Error 1
0= No scheduling error 1
1= Scheduling error 1 occurred
13 SE2 RW1C RW 0 Scheduling Error 2
0= No scheduling error 2
1= Scheduling error 2 occurred
14 ELC RW1C RW 0 Error Level Changed
Not set when error level changed during initialization.
0= No change in error level
1= Error level changed
15 IWT RW1C RW 0 Initialization Watch Trigger
The initialization is restarted by resetting IWT.
0= No missing reference message during system
startup
1= No system startup due to missing reference
message
16 WT RW1C RW 0 Watch Trigger
0= No missing reference message
1= Missing reference message (Level 0: cycle time
0xFF00)
17 AW RW1C RW 0 Application Watchdog
0= Application watchdog served in time
1= Application watchdog not served in time
18 CER RW1C RW 0 Configuration Error
Trigger out of order.
0= No error found in trigger list
1= Error found in trigger list
115
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers