• This appliance can be installed as a built in unit only. The clearances shown in
the below drawing must be followed.
• Avoid damaging the product during installation, positioning of the appliance
requires two people in order to avoid injuries or damage to the appliance.
• Your appliance should not be located in direct sunlight or exposed to
continuous heat or extremes of temperature (e.g. next to a radiator or boiler). I
f
t
his is not feasible, then you should install an insulation plate between the
appliance and the adjacent heat source.
• You should check whether there is an electrical socket available, which will be
accessible after your appliance is installed.
• Place the appliance flatly and firmly on a solid base.
• Be sure to leave enough space for the opening of the door, to avoid damage to
the appliance or personal injury
• The aperture size has to be a minimum of (H)877 x (W)560 x (D)550mm. The
cabinet in which the appliance is housed in must have a ventilation recess of
(
W)540 x (D)50mm.
• The wooden cabinet the appliance is to be housed in must not be enclosed. Th
e
b
ack wooden panel of the cabinet must either be removed completely or cut
out in accordance with the diagram on page 12. This is to allow sufficient
air
c
irculation to cool down the condenser unit for energy efficiency.
• The accessories that are required for installation are detailed below:
12 x Torx screws
2 x Foot blanking covers
2 x Door guide
2 x Door guide cover
1 x Joint
cover
2 x Door guide holder
(pre-assembled on the door)
To Next Page
Loading...
