Infinity DELTA - UNPACKING; POSITIONING; INSTALLATION OF THE SPIKED FEET

Infinity DELTA Series Instruction Manual
Congratulations on choosing Infinity DELTA Series Loudspeakers. The instructions in
this manual will help you realize the full potential of your loudspeakers.
UNPACKING
The packing materials of your DELTA Series speakers has been designed to protect
the loudspeakers from any damage due to rough handling during shipment. We
strongly suggest that you keep the packing material for future purposes, in case you
move or if your loudspeakers should require service.
POSITIONING |
Proper positioning of the speakers within the listening room is of primary importance
in order to achieve the best possible sound. Room reflections, furniture placement,
heavy drapes, window reflections and so on can influence sonic quality, balance and
the stereo image. It is essential to experiment with different locations to determine
which placement offers the best overall balance and imaging. For the best stereo
effect, the speakers should be placed at least 2 to 3 meters apart. At times, angling
the speakers slightly inward toward the listening position will add to overall
spaciousness and deliver a more realistic sound stage. Try to avoid placing the
speakers directly against the wall, or in corners of the room because this may sacrifice
depth and image and create excessive boominess. If you must place the speakers
higher than ear level tilt them downward to direct the tweeters toward your ears. When
placing bookshelf speakers on the floor, always use a pedestal, or several heavy
books to keep the speakers off the floor, or rug. Placing book-shelf speakers directly
on the floor usually creates bass heaviness which may prove to be musically incorrect.
Floor
standing
models
do
not
require
an
extra
pedestal,
since
these
systems
have
been specifically designed to perform properly resting on a floor, or carpet.
INSTALLATION OF THE SPIKED FEET
All floor standing models come with four (4) spiked feet (tiptoes) to isolate the speaker
from floor vibrations. To install the spiked feet follow these directions:
1. Turn the speaker upside down with bottom of the enclosure facing upwards.
2. Remove the four plastic screws (or tabs) from their mounting sockets Store them in
a safe place for future use.
3. Thread a nut onto each spiked foot until the nut reaches the unthreaded section. —
4. Screw the spiked feet into the four (4)
threaded mounting sockets.
ee 5. Adjust the spiked feet so they all are at
BOTTOM
OF
ENCLOSURE
Ny
the
same
height,
then
tighten
the
nuts
SILICONE to prevent the spiked feet from
ee
ae
ADHESIVE
changing
height,
or
from
rocking
side
I ess to side.
INTO 6. If you do not wish the spikes to come
THREADED
MOUNTED
SOCKET
PLACE intocontact an expensive floor, place a
plastic cover over each spiked foot,
first inserting a small amount of sili-
cone adhesive into the cavity of the
PLASTIC SCREW plastic cover. Refer to the diagram on
OR TAB the left for complete graphic details.