Black plate (290,1)
Model "INFINITI_NAVI" EDITED: 2006/ 3/ 20
incomplete map data. Please use the
direction arrow and distance informa-
tion to proceed to your destination.”
To reach your destination, refer to the
map screen. Always follow actual roads
and regulations and drive safely.
. The suggested route may not be the
shortest, nor are other circumstances
such as traffic jams considered.
. Because of the inevitable difference in
road conditions and circumstances
between the time you use this system
and the time the information was
produced for the map DVD-ROM, there
may be discrepancies in roads and
regulations. In such cases, follow the
actual information available.
. During route calculation, the map will
not scroll, however the vehicle icon will
move with the actual vehicle’s move-
ment.
. During route calculation, buttons such
as <MAP>, <DEST>, <ZOOM OUT> and
<ZOOM IN> and the INFINITI controller
will be disabled.
. In some cases, after the calculation is
complete, the calculated route may not
be immediately displayed.
. Waypoints that have been passed will
be disregarded by rerouting calcula-
tion.
. If you scroll the map while the sug-
gested route is being drawn, it may
take more time to finish drawing.
. If waypoints are set, the system calcu-
lates multiple routes between way-
points simultaneously, and the
following may result.
— If one section between waypoints
cannot be calculated, none of the
route will be displayed.
— The route may not connect comple-
tely at some waypoints.
— The route may require a U-turn close
to some waypoints.
— Route calculation may not be com-
pleted in the following cases.
— If there is no main road within a
range of 1.5 miles (2.5 km) from the
vehicle, a message saying so will
appear on the screen. Try recalculat-
ing when the vehicle is closer to a
main road.
— If there is no main road within a
range of 1.5 miles (2.5 km) from the
destination or waypoint, a message
saying so will appear on the screen.
Try setting the location closer to a
main road.
— If the vehicle is too close to the
destination or if there are no roads
to the destination, a message say-
ing so will appear on the screen.
— If it is impossible to reach the
destination or waypoints because
of traffic regulations, etc.
— If the only route to reach the
destination or waypoints is extre-
mely complicated.
— If the destination, current vehicle
position or waypoint is within the
“Avoid Area”.
— If a part of the route is included in
the “Avoid Area”.
— The following may occur when the
route is displayed.
— If you calculate a route on a main
road, the starting point of the route
may not exactly match the current
vehicle location.
— The endpoint of the route may not
exactly match the destination.
10. General system information
10-10
To Next Page
Loading...