Black plate (312,1)
Model "INFINITI_NAVI" EDITED: 2006/ 3/ 20
Symptom Possible cause Possible solution
The part of the route that you have
already passed is deleted.
A route is managed by sections between waypoints. If you passed the
first waypoint, the section between the starting point and the waypoint
is deleted. (It may not be deleted depending on the area.)
This is not a malfunction.
An indirect route is suggested. If there are restrictions (such as one-way streets) on roads close to the
starting point or destination, the system may suggest an indirect route.
Adjust the location of the starting point or destination.
The system may suggest an indirect route because route calculation
does not take into consideration some areas such as narrow streets
(gray roads).
Reset the destination to a main or ordinary road, and
recalculate the route.
The landmark information does not
correspond to the actual information.
This may be caused by insufficient or incorrect data on the DVD-ROM. Updated information will be included in the next
version of the map DVD-ROM.
The suggested route does not exactly
connect to the starting point, way-
points, or destination.
There is no data for route calculation closer to these locations. Set the starting point, waypoints and destination on a
main road, and perform route calculation.
11. Troubleshooting guide
11-8
To Next Page
Loading...