[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
beam assist system is operational. (See
“High beam assist” (P.2-40).)
High beam indicator light
V37-D-121025-CFCB3FB3-DC4F-4572-AFDF-7DC4BD932014
This light comes on when the headlight
high beam is on and goes out when the low
beam is selected.
Idling Stop System indicator
light (if so equipped)
GUID-323942AC-6B83-4A54-82FF-E0A7BC154EF2
The Idling Stop System indicator light
illuminates when the Idling Stop System
is activated.
The Idling Stop System indicator light
blinks at a high speed, when the engine
hood is open while the engine is stopped
by the system.
The Idling Stop System indicator light
blinks at a low speed, when the Idling
Stop System is malfunctioning.
NOTE:
. When the Idling Stop System indicator
light blinks at a high speed (twice
approximately every 1 second), be sure
to close the engine hood. When the
engine hood is open, the engine will be
in the normal stopped state. In this
case, restart the engine using the
ignition switch.
. When the Idling Stop System indicator
light blinks at a low speed (once
approximately every 1 second), it is
recommended you have the system
checked, and if necessary repaired, by
an INFINITI retailer promptly.
Malfunction Indicator Light
(MIL)
V37-D-121025-5EB179EE-ACAB-4F8B-B435-E99A0A72924E
If the malfunction indicator light comes on
steady or blinks while the engine is
running, it may indicate a potential emis-
sion control malfunction.
The malfunction indicator light may also
come on steady if the fuel-filler cap is loose
or missing, or if the vehicle runs out of fuel.
Check to make sure the fuel-filler cap is
installed and closed tightly, and that the
vehicle has at least 3 US gallons (11.4
liters) of fuel in the fuel tank.
After a few driving trips, the
light
should turn off if no other potential
emission control system malfunction ex-
ists.
If this indicator light remains on for 20
seconds and then blinks for 10 seconds
when the engine is not running, it indicates
that the vehicle is not ready for an
emission control system inspection/main-
tenance test. (See “Readiness for Inspec-
tion/Maintenance (I/M) test (US only)”
(P.10-24).)
Operation:
V37-D-121025-2E89CD97-8BAB-4B9C-9C0A-62F224C54B9E
The malfunction indicator light will come
on in one of two ways:
. Malfunction indicator light on steady —
An emission control system malfunc-
tion has been detected. Check the fuel-
filler cap if the Loose Fuel Cap warning
appears in the vehicle information dis-
play. If the fuel-filler cap is loose or
missing, tighten or install the cap and
continue to drive the vehicle. The
light should turn off after a few driving
trips. If the
light does not turn off
after a few driving trips, have the
vehicle inspected. It is recommended
you visit an INFINITI retailer for this
service. You do not need to have your
vehicle towed to the retailer.
. Malfunction indicator light blinking —
An engine misfire has been detected
which may damage the emission con-
trol system.
Instruments and controls 2-17
Condition:
To Next Page
Loading...