[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
JVI0686X
High beam assist operations:
GUID-AD2477C0-5AA1-445C-BD30-C04059847F2B
To activate the high beam assist system,
turn the headlight switch to the AUTO
position
*
1
and push the lever forward
*
2
(high beam position). The high beam assist
indicator light in the meter will illuminate
while the headlights are turned on.
If the high beam assist indicator light does
not illuminate in the above condition, it
may indicate that the system is not
functioning properly. It is recommended
you have the system checked by an INFINITI
retailer.
When the vehicle speed lowers to less than
approximately 17 MPH (27 km/h), the
headlight remains the low beam.
To turn off the high beam assist system,
turn the headlight switch to the
position or select the low beam position
by placing the lever in the neutral position.
JVI0670X
Ambient image sensor maintenance:
GUID-C5151859-1053-4B17-84C8-598801BD0D23
The ambient image sensor
*
1
for the high
beam assist system is located in front of
the inside mirror. To keep the proper
operation of the high beam assist system
and prevent a system malfunction, be sure
to observe the following:
. Always keep the windshield clean.
. Do not attach a sticker (including
transparent material) or install an
accessory near the ambient image
sensor.
. Do not strike or damage the areas
around the ambient image sensor. Do
not touch the sensor lens that is
Instruments and controls 2-41
Condition:
To Next Page
Loading...