[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
3-22 Pre-driving checks and adjustments
REMOTE STARTING THE ENGINE
GUID-A405E9BD-0C48-4DE5-945E-6F650CF352E4
To use the remote start function to start the
engine, perform the following:
1. Aim the Intelligent Key at the vehicle.
2. Push the LOCK
button to lock all
doors.
3. Within 5 seconds push and hold the
remote engine start
button until
the turn signal lights flash and the tail
lights illuminate. If the vehicle is not
within view, push and hold the remote
engine start
button for at least 2
seconds.
The following events will occur when the
engine starts:
. The front parking lights will turn on and
remain on as long as the engine is
running.
. The doors will be locked and the air
conditioner system may turn on.
. The engine will continue to run for
about 10 minutes. Repeat the steps to
extend the time for an additional 10
minutes. See “Extending engine run
time” (P.3-22).
Depress and hold the brake pedal, then
place the ignition switch in the ON position
before driving. For further instructions, see
“Driving the vehicle” (P.5-16).
EXTENDING ENGINE RUN TIME
GUID-BA5C7406-D1DF-49A9-9254-BD60722F6D99
The remote engine start function can be
extended one time by performing the steps
listed in “Remote starting the engine” (P.3-
22). Run time will be calculated as follows:
. The first 10 minute run time will start
when the remote engine start function
is performed.
. The second 10 minutes will start im-
mediately when the remote engine start
function is performed. For example, if
the engine has been running for 5
minutes, and 10 minutes are added,
the engine will run for a total of 15
minutes.
. Extending engine run time will count
towards the two remote start limit.
A maximum of two remote starts, or a
single start with an extension, are allowed
between ignition cycles.
The ignition switch must be cycled to the
ON position and then back to the OFF
position before the remote engine start
procedure can be used again.
CANCELING A REMOTE START
GUID-8BB90049-D5BB-4B6C-AA6D-EBF1DF2B034C
To cancel a remote start, perform one of the
following:
. Aim the Intelligent Key at the vehicle
and push and hold the remote engine
start
button until the parking lights
turn off.
. Turn on the hazard warning flashers.
. Cycle the ignition switch ON and then
OFF.
. The extended engine run time has
expired.
. The first 10 minute timer has expired.
. The engine hood has been opened.
. The shift lever is moved out of P (Park).
. The alarm sounds due to illegal entry
into the vehicle.
. The ignition switch is pushed without
an Intelligent Key in the vehicle.
. The ignition switch is pushed with an
Intelligent Key in the vehicle but the
brake pedal is not depressed.
Condition:
To Next Page
Loading...