[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
JVP0240X
MEMORY STORAGE
V37-D-121025-C3253FC6-067F-4EF6-AC8E-443DBC2A82D7
Two positions for the driver’s seat, steering
column and outside mirrors can be stored
in the automatic drive positioner memory.
Follow these procedures to use the mem-
ory system.
1. Adjust the driver’s seat, steering col-
umn and outside mirrors to the desired
positions by manually operating each
adjusting switch. For additional infor-
mation, see “Seats” (P.1-2), “Tilt/tele-
scopic steering” (P.3-29) and “Outside
mirrors” (P.3-32).
2. Push the SET switch and, within 5
seconds, push the memory switch (1
or 2) fully for at least 1 second.
The indicator light for the pushed
memory switch will stay on for approxi-
mately 5 seconds after pushing the
switch.
When the memory is stored in the
memory switch (1 or 2), a buzzer will
sound.
If memory is stored in the same
memory switch, the previous memory
will be deleted.
Confirming memory storage
V37-D-121025-CE2091ED-9082-42A3-AC8C-4E5B88DA32AD
Push the SET switch. If the main memory
has not been stored, the indicator light will
come on for approximately 0.5 seconds.
When the memory has stored in position,
the indicator light will stay on for approxi-
mately 5 seconds.
Selecting the memorized position
V37-D-121025-812ACCF7-5E50-4166-B150-60EB8EB9A549
1. Move the shift lever to the P (Park)
position.
2. Push the memory switch (1 or 2) fully
for at least 1 second.
The driver’s seat, steering column and
outside mirrors will move to the mem-
orized position with the indicator light
flashing, and then the light will stay on
for approximately 5 seconds.
Linking log-in function to a stored
memory position
V37-D-121025-AB3F7AAC-59C4-4119-9D25-7D847B211DA2
The log-in function can be linked to a
stored memory position with the following
procedure.
1. Place the ignition switch in the ON
position while carrying an Intelligent
Key that was registered to the vehicle
with the log-in function. For more
details, see “Log-in function” (P.3-16).
2. Adjust the position of the driver’s seat,
steering column and outside mirrors
manually. See “Seats” (P.1-2), “Tilt/
telescopic steering” (P.3-29) and “Out-
side mirrors” (P.3-32).
3. Place the ignition switch in the OFF
position.
The next time you log in (selecting the user
on the display) after placing the ignition
switch in the ON position while carrying the
Intelligent Key, the system will automati-
cally adjust to the memorized driving
position.
Pre-driving checks and adjustments 3-35
Condition:
To Next Page
Loading...