[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
JVS0610X
*
1
Vehicle information display
*
2
Dynamic driver assistance switch
SYSTEM TEMPORARILY UNAVAIL-
ABLE
GUID-44FB9B2F-FA84-43E5-8131-D175C39FD782
Under the following conditions, a chime
will sound, the “currently unavailable”
warning message will appear in the vehicle
information display
*
1
and the BSI system
will be turned off automatically. The BSI
system will not be available until the
conditions no longer exist.
. When the VDC system (except TCS
function) or ABS operates.
. When the VDC system is turned off.
. When the INFINITI Drive Mode Selector
is turned to the SNOW mode.
Action to take:
When the above conditions no longer exist,
push the dynamic driver assistance switch
*
2
again to turn the BSI system back on.
When radar blockage is detected, the BSI
system will be turned off automatically, a
chime will sound and the “side radar
obstruction” warning message will appear
in the vehicle information display
*
1
.
The BSI system is not available until the
conditions no longer exist. For additional
information, see “System maintenance”
(P.5-62).
Action to take:
When the above conditions no longer exist,
turn the BSI system on again. If the “side
radar obstruction” warning message ap-
pears even after the BSI system is turned
on again, stop the vehicle in a safe
location, place the shift lever in the P
(Park) position and turn the engine off.
Check for and remove objects obscuring
the radar sensors on the rear bumper, and
restart the engine.
If the vehicle is parked in direct sunlight
under high temperature conditions (over
approximately 1048F (408C)) and then the
BSI system is turned on, the BSI system
may be deactivated automatically. The
“high cabin temperature” warning mes-
sage will appear in the vehicle information
display
*
1
.
Action to take:
When the interior temperature is reduced,
push the dynamic driver assistance switch
*
2
again to turn the BSI system back on.
SYSTEM MALFUNCTION
V37-D-121025-C7FB4764-0BE7-4C90-B8C9-2019CD0D1E1E
When the BSI system malfunctions, it will
be turned off automatically, a chime will
sound, and the system “malfunction”
warning message with the driver assist
system blind spot indicator (orange) will
appear in the vehicle information display.
Action to take:
Stop the vehicle in a safe location and
place the shift lever in the P (Park) position.
Turn the engine off and restart the engine.
If the system “malfunction” warning mes-
sage with the driver assist system blind
spot indicator (orange) continues to be
displayed, have the BSI system checked. It
is recommended you visit an INFINITI
retailer for this service.
Starting and driving 5-61
Condition:
To Next Page
Loading...