[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
5-110 Starting and driving
TURNING THE FEB SYSTEM ON/OFF
GUID-1196D6D5-BB9C-49E2-9A40-2BA55A8EF2B2
Perform the following steps to turn the FEB
system on or off.
1. Push the MENU button
*
3
and touch
[Driver Assistance] on the lower display
*
2
.
2. Touch [Emergency Assist].
3. Touch [Forward emergency braking] to
turn the system ON/OFF.
When the FEB system is turned off, the FEB
system warning light (orange)
*
1
illumi-
nates.
The FEB system will be automatically
turned ON when the engine is restarted.
NOTE:
The PFCW system is integrated into the
FEB system. There is not a separate
selection in the display for the PFCW
system. When the FEB is turned off, the
PFCW system is also turned off.
FEB SYSTEM LIMITATIONS
GUID-817E251B-D5D4-45FF-A343-2FAEA5BFE495
WARNING
Listed below are the system limitations for
the FEB system. Failure to operate the
vehicle in accordance with these system
limitations could result in serious injury or
death.
. The FEB system cannot detect all vehi-
cles under all conditions.
. The radar sensor does not detect the
following objects:
—
Pedestrians, animals or obstacles in
the roadway
—
Oncoming vehicles
—
Crossing vehicles
. The radar sensor has some performance
limitations. If a stationary vehicle is in
the vehicle’s path, the FEB system will
not function when the vehicle is driven at
speeds over approximately 45 MPH (70
km/h).
. The radar sensor may not detect a
vehicle ahead in the following condi-
tions:
—
Dirt, ice, snow or other material
covering the radar sensor.
—
Interference by other radar sources.
—
Snow or road spray from traveling
vehicles.
—
If the vehicle ahead is narrow (e.g.
motorcycle)
—
When driving on a steep downhill
slope or roads with sharp curves.
. In some road or traffic conditions, the
FEB system may unexpectedly push the
accelerator pedal up or apply partial
braking. When acceleration is necessary,
continue to depress the accelerator
pedal to override the system.
. Braking distances increase on slippery
surfaces.
. The system is designed to automatically
check the sensor’s functionality, within
certain limitations. The system may not
detect some forms of obstruction of the
sensor area such as ice, snow, stickers,
for example. In these cases, the system
may not be able to warn the driver
properly. Be sure that you check, clean
and clear the sensor area regularly.
Condition:
To Next Page
Loading...