[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
JVE0194X
2.0L turbo gasoline engine
4. For 2.0L turbo gasoline engine model:
Pull up the engine cover and remove it.
5. Connect jumper cables in the sequence
as illustrated (
*
1
?
*
2
?
*
3
?
*
4
).
CAUTION
. Always connect positive (+) to positive
(+) and negative (−) to body ground (as
illustrated) − not to the battery.
. Make sure the jumper cables do not
touch moving parts in the engine com-
partment and that clamps do not contact
any other metal.
6. Start the engine of the booster vehicle
*
A
and let it run for a few minutes.
7. Keep the engine speed of the booster
vehicle
*
A
at about 2,000 rpm, and
start the engine of the vehicle being
jump started
*
B
.
CAUTION
Do not keep the starter motor engaged for
more than 10 seconds. If the engine does
not start right away, push the ignition
switch to the OFF position and wait 10
seconds before trying again.
8. After starting your engine, carefully
disconnect the negative cable and then
the positive cable (
*
4
?
*
3
?
*
2
?
*
1
).
9. Replace the vent caps (if so equipped).
Be sure to dispose of the cloth used to
cover the vent holes as it may be
contaminated with corrosive acid.
10.Put the battery cover and the engine
cover back to the original location.
NOTE:
For 2.0L turbo gasoline engine models, if
the engine cannot be started after the
procedure above, the auxiliary battery may
be discharged. Connect the jumper cables
to the auxiliary battery and apply the
procedure shown in “Auxiliary battery (for
2.0L turbo gasoline engine models)” (P.6-
14).
In case of emergency 6-13
Condition:
To Next Page
Loading...