[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
JVE0143X
6. Open the trunk.
7. Remove the clip
*
C
*
D
, then remove
the trunk trim.
8. Remove the vent caps, if so equipped,
on the battery.
9. Connect the jumper cables in the
sequence as illustrated (
*
1
,
*
2
,
*
3
,
*
4
).
CAUTION
. Always connect positive + to positive +
and negative 7 to body ground, NOT to
the battery’s negative 7.
. Be sure that the jumper cables do not
touch moving parts in the engine com-
partment.
. Be sure that the jumper cable’s clamps
do not contact any other metal.
10.Start the engine of the booster vehicle
*
A
and let it run for a few minutes.
11.Depress the accelerator pedal of the
booster vehicle
*
A
at about 2,000 rpm.
12.Start the engine of the jumped vehicle
*
B
in the normal manner.
CAUTION
Never keep the starter motor engaged for
more than 10 seconds. If the engine does
not start right away, push the ignition
switch to the “LOCK” position and wait at
least 10 seconds before trying again.
13.After the engine is started, carefully
disconnect the jumper cables in the
opposite sequence from that illustrated
(
*
4
,
*
3
,
*
2
,
*
1
).
14.Replace the vent caps, if removed.
15.Replace the trunk trim.
NOTE:
. If the engine cannot be started after the
procedure above, both the main and
the auxiliary batteries may be dis-
charged. Jump-start the vehicle by
connecting one set of the jumper
cables to the main battery and another
set of the jumper cables to the auxiliary
battery at the same time, using the
procedure for jump-starting each bat-
tery.
. If the engine cannot be started, even
when the main and the auxiliary
In case of emergency 6-15
Condition:
To Next Page
Loading...