[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
SAI0051
Positioning hooks
The illustration shows the location of the
floor mat positioning hooks.
SEAT BELTS
V37-D-121025-2D317E9D-E485-4E01-BEF8-63AE0061A86C
The seat belts can be cleaned by wiping
them with a sponge dampened in a mild
soap solution. Allow the belts to dry
completely before using them.
See “Seat belts” (P.1-12).
WARNING
Do not allow wet seat belts to roll up in the
retractor. NEVER use bleach, dye, or chemi-
cal solvents to clean the seat belts, since
these materials may severely weaken the
seat belt webbing.
V37-D-121025-7C9F6819-C67C-4001-ADB4-4331407552AC
MOST COMMON FACTORS CONTRI-
BUTING TO VEHICLE CORROSION
V37-D-121025-E979CBFD-D47E-46D2-AB44-0988347AF315
. The accumulation of moisture-retaining
dirt and debris in body panel sections,
cavities, and other areas.
. Damage to paint and other protective
coatings caused by gravel and stone
chips or minor traffic accidents.
ENVIRONMENTAL FACTORS INFLU-
ENCE THE RATE OF CORROSION
V37-D-121025-C2F6F55B-7D15-4DC8-A7A4-CB5B62B9E8C9
Moisture
V37-D-121025-12E981E2-C1A4-4D98-9FBC-150933E5F21D
Accumulation of sand, dirt and water on
the vehicle body underside can accelerate
corrosion. Wet floor coverings will not dry
completely inside the vehicle, and should
be removed for drying to avoid floor panel
corrosion.
Relative humidity
V37-D-121025-64711E0F-757E-409A-B8A7-2864F3659D0F
Corrosion will be accelerated in areas of
high relative humidity, especially those
areas where the temperatures stay above
freezing where atmospheric pollution ex-
ists, or where road salt is used.
Appearance and care 7-7
CORROSION PROTECTION
Condition:
To Next Page
Loading...