[ Edit: 2016/ 8/ 1 Model: 2017MY INFINITI Q70(Y51) OM17E00Y51U0 ]
2-20 Instruments and controls
tion/Maintenance (I/M) test (US only)”
(P.10-23).)
Operation:
GUID-6187229E-DFEB-4366-B5DF-C9DC9EE6B6CF
The malfunction indicator light will come
on in one of two ways:
. Malfunction indicator light on steady —
An emission control system malfunc-
tion has been detected. Check the fuel-
filler cap if the LOOSE FUEL CAP warning
appears on the vehicle information
display. If the fuel-filler cap is loose or
missing, tighten or install the cap and
continue to drive the vehicle. The
light should turn off after a few driving
trips. If the
light does not turn off
after a few driving trips, have the
vehicle inspected. It is recommended
you visit an INFINITI retailer for this
service. You do not need to have your
vehicle towed to the retailer.
. Malfunction indicator light blinking —
An engine misfire has been detected
which may damage the emission con-
trol system.
To reduce or avoid emission control
system damage:
1) Do not drive at speeds above 45
MPH (72 km/h).
2) Avoid hard acceleration or decelera-
tion.
3) Avoid steep uphill grades.
4) If possible, reduce the amount of
cargo being hauled or towed.
The malfunction indicator light may
stop blinking and remain on.
Have the vehicle inspected. It is re-
commended you visit an INFINITI retai-
ler for this service. You do not need to
have your vehicle towed to the retailer.
CAUTION
Continued vehicle operation without having
the emission control system checked and
repaired as necessary could lead to poor
driveability, reduced fuel economy, and
possible damage to the emission control
system.
Security indicator light
Y51D-V-E01-8635F0ED-0D0D-4E28-95C0-B27FBF6F6EDB
The light blinks when the ignition switch is
in the ACC, OFF or LOCK position. This
function indicates the security system
equipped on the vehicle is operational.
If the security system is malfunctioning,
this light will remain on while the ignition
switch is in the ON position. For additional
information, see “Security systems” (P.2-
31).
Turn signal/hazard indicator
lights
Y51D-V-E01-10692ED4-BF78-4A36-BB9C-69C6F64C78C4
The light flashes when the turn signal
switch lever or hazard switch is turned on.
Vehicle Dynamic Control (VDC)
off indicator light
Y51D-V-E01-8CC0C384-2200-42D1-96F4-B39EB909E790
When the ignition switch is in the ON
position, the Vehicle Dynamic Control
(VDC) off indicator light illuminates and
then turns off. The VDC off indicator light
comes on when the VDC off switch is
pushed to OFF. This indicates that the
vehicle dynamic control system and trac-
tion control system are not operating.
Condition:
To Next Page
Loading...
