[ Edit: 2016/ 8/ 1 Model: 2017MY INFINITI Q70(Y51) OM17E00Y51U0 ]
2. The indicator light will begin to flash
after 20 seconds. Without releasing the
HomeLink
®
button, proceed with “Pro-
gramming HomeLink
®
” - Step 1.
For questions or comments, contact
HomeLink
®
at: www.homelink.com or 1-
800-355-3515.
The HomeLink
®
Universal Transceiver but-
ton has now been reprogrammed. The new
device can be activated by pushing the
HomeLink
®
button that was just pro-
grammed. This procedure will not affect
any other programmed HomeLink
®
but-
tons.
IF YOUR VEHICLE IS STOLEN
Y51D-V-E01-2BD85D86-7F7F-430B-8EC0-24D0C3D0258B
If your vehicle is stolen, you should change
the codes of any non-rolling code device
that has been programmed into
HomeLink
®
. Consult the Owner’s Manual
of each device or call the manufacturer or
retailer of those devices for additional
information.
When your vehicle is recovered, you will
need to reprogram the HomeLink
®
Uni-
versal Transceiver with your new transmit-
ter information.
FCC Notice:
For USA:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.
NOTE:
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
For Canada:
This device complies with Industry Canada
licence-exempt RSS standard(s). Opera-
tion is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference, including inter-
ference that may cause undesired opera-
tion of the device.
Instruments and controls 2-67
Condition:
To Next Page
Loading...
