[ Edit: 2016/ 8/ 1 Model: 2017MY INFINITI Q70(Y51) OM17E00Y51U0 ]
following methods:
1. Push the CANCEL switch. The SET
indicator will turn off.
2. Tap the brake pedal. The SET indicator
will turn off.
3. Turn the MAIN switch off. Both the MAIN
switch indicator and SET indicator will
turn off.
To reset at a faster cruising speed, use one
of the following three methods:
1. Depress the accelerator pedal. When
the vehicle attains the desired speed,
push and release the COAST/SET
switch.
2. Push and hold the ACCELERATE/RE-
SUME set switch. When the vehicle
attains the desired speed, release the
switch.
3. Push, then quickly release the ACCEL-
ERATE/RESUME switch. Each time you
do this, the set speed will increase by
about 1 MPH (1.6 km/h).
To reset at a slower cruising speed, use
one of the following three methods:
1. Lightly tap the brake pedal. When the
vehicle attains the desired speed, push
the COAST/SET switch and release it.
2. Push and hold the COAST/SET switch.
Release the switch when the vehicle
slows down to the desired speed.
3. Push, then quickly release the COAST/
SET switch. Each time you do this, the
set speed will decrease by about 1 MPH
(1.6 km/h).
To resume the preset speed, push and
release the ACCELERATE/RESUME switch.
The vehicle will resume the last set cruising
speed when the vehicle speed is over 25
MPH (40 km/h).
System temporarily unavailable
Y51D-V-E01-6261B5E2-E00B-4FC7-A965-A632DF071762
A chime sounds under the following con-
ditions and the control is automatically
canceled.
. When the vehicle slows down more than
8 MPH (13 km/h) below the set speed
. When the shift lever is not in the D
(Drive) or manual shift mode
. When the parking brake is applied.
. When the VDC operates (including the
traction control system)
. When a wheel slips
JVS0715X
Warning light
Y51D-V-E01-72526CC3-E5EC-44B6-9285-C81F69E550BE
When the system is not operating properly,
the chime sounds and the system warning
light (orange) will come on.
Action to take:
GUID-3B2F2200-4E20-496A-B6BE-336F8D317A7D
If the warning light comes on, park the
vehicle in a safe place. Turn the engine off,
restart the engine, resume driving and then
perform the setting again.
If it is not possible to set or the indicator
stays on, it may indicate that the system is
malfunctioning. Although the vehicle is
still driveable under normal conditions,
have the vehicle checked. It is recom-
Starting and driving 5-93
Condition:
To Next Page
Loading...
