2-13EonStor DS 3000 Series Hardware Manual
2.2.4 Installing the controller
To install the controller:
1. Shut down your system.
2. On the dummy controller, unfasten the retention screws under the ejection levers.
Ejection lever Ejection lever
Mounting hole Mounting hole
3. Push down the ejection levers to dislodge the controller from the system, then pull to remove from
the enclosure.
4. Insert the controller carefully into the module slot. When you feel a contact resistance, push the
controller with a small but careful force, then move the ejection levers upwards to secure the
controller to the enclosure.
To Next Page
Loading...
