4-4 Chapter 4: System maintenance
4.1.2 Replacing the hard drive
WARNING!
• Ensure to have a replacement ready before replacing the hard drive. DO NOT leave the drive tray
open for long periods to prevent disruption of internal airow.
• Handle the hard drives with extreme care. Hold them by the edges and avoid touching the circuits
and interface connectors.
To replace the hard drive:
1. Identify the faulty hard drive using the SANWatch software or the LEDs on the drive tray.
NOTE: See section Hard drive designation for the order of the drive bays.
2. When the faulty hard drive is located, turn the bezel lock to its unlock position using a small-sized
athead screwdriver.
3. Press the release button to open the bezel, wait for 30 seconds for the hard drive to spin down,
then gently pull out the tray.
To Next Page
Loading...
