35
SAS Interface
The SAS interface features a dual-ported connectivity with pins on both sides of its
connector that include SAS primary links (1), power link (2) and underneath it, the
SAS secondary links (3). The SATA drives have only one port that includes the SATA
physical links (4) and the power link (5). In a redundant-controller system, the
MUX-enabled drive trays must be separately purchased and applied. The
single-controller JBODs do not require MUX kit.
Dual-ported SAS and Single-port SATA Connectors
WARNING
The hard drives and drive trays should only be installed into the system after the
enclosure has been mounted into the cabinet / rack. If the hard drives are installed
first, the system will be too heavy to handle and the possible impact during
installation may damage your hard drives.
Handle hard drives with extreme care and observe all ESD prevention methods
when installing drives.
Only use screws supplied with the system package. Longer screws may damage the
drive.
To Next Page
Loading...
