40
Flash Backup Module & Battery Backup Unit
Please read the following sections on how to install the battery backup module and
flash backup module into the controller module. Always place the controller on a
clean, static-free surface and hold the controller only by its metal canister and never
touch the circuit board or connector pins.
Flash Backup Module Installation
Once the controller has been removed, place the base plate into the designated
location in the controller (shown in green) and secure it using the supplied flathead
screws (shown in red). The screws are secured underneath the controller. Secure
the three copper stands into the locations shown below (shown in blue).
Lower the PCB board onto the controller while matching the holes to the copper
stands and secure it using the supplied truss head screws.
To Next Page
Loading...
