Infortrend EonStor DS 1012 - Power on Status Check

89
Power On Status Check
As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up red / amber nor should you hear an audible alarm from the
system. You should begin verifying system statuses via the following monitoring
interfaces:
 LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to
System Monitoring).
Controller LEDs:
1. Ctrl Status LED: On (green) 4. CBM Status LED: On (green) or
Off (if not installed)
2. C_Dirty LED: Off 5. Hst Bsy LED: On (green)
3. Temp LED: Off 6. Drv Bsy LED: On (green)
1 2 3
4 5 6