EonStor / EonStor DS S12/S16/S24 Series
5. Inst
all the replacement module
its lowest position so that the sa
. Make sure the extraction handle (1) is held at
ddle notches on the sides of the handle can snap
U
wards
to secure the module.
onto the metal anchor pins (2) on the interior walls of the PSU slot. Push the PS
into chassis, and when you feel the contact resistance, pull the handle up
6. Secure the PSU to the system by fastening the retention screw through the PSU
extraction handle.
nect the power cord. 7. Recon
8. Power on the PSU module.
157
To Next Page
Loading...
