IFT-9279CSlider36 Slide Rail Kit
188
1. Determine rail installation
Installation Procedure
position. The screw-hole locations that secure the slide rail
u
n M5 flathead screws
(04). Between the two M5 flathead screws on the front rack post, leave 4-hole spaces
(indicated by the blue circle).
sing M5 flathead screws (04) must match on front and rear posts. Place two cage
uts (06) on the two outer most holes of the front post between the
06
04
04
Rear rac Front rack post
Determine rail length, secure rail to posts and place cage buts
2. Attach filler plates (07) to the left / right ears of the enclosure using cross recess
flathead screws #6-32 (05). The R and J on the filler plates indicate RAID and JBOD,
respectively.
k post
206
To Next Page
Loading...
