EonStor / EonStor DS S12/S16/S24 Series
76
Controller Module of JBOD Models
The expansion JBOD controllers features SAS expansion ports (1), SAS expansion
port status LEDs* (2), controller status LEDs (3), extraction levers and retention
screws (4) and convection holes* (5).
* indicates the component is not present on all models
J1000 JBOD models (8470 SAS connector type)
1
44
3
J1002R & J2000 JBOD models (8088 SAS connector type)
11 22
3
4
4
5
The expansion controller contains a circuit board within a metal canister, interfaced
through hot-swap docking connectors at the back-end. Two SAS wide ports on the
interface faceplate connect to a managing RAID system or other JBODs
.
WARNING
The only time you should remove the controller is to replace a failed controller. The
controller is built of sensitive components and unnecessary tampering can damage
the controller.
37
To Next Page
Loading...
